Tyre pressure is the easiest part of your Setup to change in the paddock, and the easiest to forget to write down.
Tyre pressures for a track day
Why tyre pressures matter on track, when to check them and how to change them one step at a time.
Read this guide as MarkdownWrite down your pressures before a Session, check them again after it, and change one thing at a time.
Why they matter
Tyre pressure is one part of your Setup, with suspension settings and wheel alignment.
Tyres get hot on track, so the pressure after a Session is higher than before it.
What to write down
- Cold pressures before the first Session.
- Hot pressures straight after each Session. Apex Scout asks for them after every Session.
- Your hot target, once per Track Day, if you have one.
How to change them
- Write down the pressures you have now.
- Change one thing: the pressure, nothing else.
- Drive a Session in the same dry conditions and compare your laps.
- Plan at least 5 flying laps, so there are enough to tell.
- To be sure it was the change, change it back in a later Session and check.
What to leave alone
Wheel alignment can't be changed in the paddock, so leave it as it is.
If you're unsure
What pressure should I run?
That depends on your Car, your tyres and the Circuit, so this guide gives no number.
Next: your free Preview
Give Apex Scout your Export and your free Preview shows the one biggest corner loss in full, before you pay.
See your biggest corner loss before you pay.
Give Apex Scout the Export of a past Track Day. Your free Preview shows the one corner where you lose the most time, drawn in full on the map.